Childproofing Electrical Outlets: A Guide for Parents
Most parents baby proof the obvious things first. Cupboard locks, stair gates, corner guards on the coffee table. Power points rarely make that first pass. Australian outlets already look safer than the ones parents grew up seeing on American television. That is true to a point, but it is not the whole story.
Australian power points have built in shutters. They stop a single object being pushed into one hole. What they do not stop is a toddler yanking a phone charger out of the wall and chewing the cord. Or pulling a power board off a shelf because three chargers were plugged into it. Those are the incidents Sharpe electricians actually get called out for, not exposed pins.
This guide covers the real risks in a family home and the practical steps worth taking room by room.
Are Australian Power Points Already Childproof?
Every power point sold in Australia has to meet AS/NZS 3112. That standard has required shuttered sockets for a long time. The shutters only open when both pins of a plug press against them at once, with equal pressure. A single key or hairpin cannot force one open on its own. An updated version, AS/NZS 3112:2025, adds shutter and cover requirements to portable power boards and double adaptors too, closing off a common gap in the old rules.
So a standard, undamaged Australian outlet is harder to defeat than the plug in covers sold overseas. That said, three things still catch parents out. Old points can crack or loosen with age, weakening the shutter mechanism. Older double adaptors and power boards may predate the newer shutter rules. And a plug left half withdrawn can expose enough of the pins for small fingers to reach.
The Real Risks We See on Adelaide Jobs
Cracked or discoloured power points come up constantly on electrical safety checks in homes with young kids. A point knocked by a pram or a toy trolley enough times eventually loses its shutter tension. That is when it stops doing its job.
Cords are the bigger everyday hazard. Phone chargers left plugged in at floor level. Laptop leads trailing across a lounge room. Kettle cords hanging over a bench edge. Toddlers pull on anything within reach, and a hot iron or a full kettle coming down is far worse than the outlet underneath it. Power boards stacked with adaptors are also a fire risk in their own right.
Then there is the switchboard. A lot of Adelaide’s older housing stock, especially through the inner suburbs, still has partial safety switch coverage rather than protection on every circuit. That matters more with kids in the house, since a safety switch is the backstop that catches a fault before it becomes a shock.
Safety Switches Are the Real Backstop
A residual current device, usually called a safety switch or RCD, monitors the current flowing through a circuit. If it senses a small leak to earth, the kind that happens when a person becomes part of the circuit, it cuts power in a fraction of a second. It is the single biggest factor in whether a shock in the home is a scare or something far worse.
Plenty of older Adelaide homes only have one safety switch covering part of the switchboard. Some have none at all. New builds require RCD protection on every circuit, but an eighties era house was never held to that standard. Checking your safety switch coverage is one of the more useful things a parent can do.
If your home still has ceramic fuses instead of circuit breakers, mention it to your electrician too. It is a strong sign the whole board predates modern standards, and a broader switchboard upgrade may be the better fix rather than adding a safety switch to an old board.
Practical Steps for the Rooms Kids Actually Use
Start with the rooms where children spend the most time on the floor. Lounge rooms, playrooms and bedrooms are where cords and chargers pile up.
- Unplug chargers fully rather than leaving them dangling from the wall
- Move power boards up off the floor and behind furniture where possible
- Coil or clip excess cord length so nothing trails within reach of a crawling baby
- Check any power point a pram or toy box regularly bumps into for cracks
- Keep kettles, irons and straighteners unplugged and back from bench edges
If you are renovating a nursery or playroom, ask about additional power point installation higher up the wall, out of crawling reach. Kitchens and living areas with a lot of charging also suit a USB powerpoint upgrade, which means fewer bulky chargers cluttering low sockets.
Comparing the Common Childproofing Options
Plug in outlet covers are cheap and easy to find. Some toddlers lever them out within a few months, though. They are a stopgap, not a permanent fix, and they do nothing for the safety switch coverage behind the wall.
Furniture placement works well in specific spots. Blocking a low socket with a bookshelf helps, but it will not work for points you need daily, like the one behind the television.
A proper safety check actually finds problems rather than covering them up. It tests every circuit, checks switch response times, and flags parts past their working life. For most families, tidy cord habits, full RCD coverage, and an occasional check cover the real risk far better than a bag of plastic plugs alone.
Working Out What Your Home Actually Needs
Every home is different. The right approach depends on the age of your wiring, how many kids are in the house, and which rooms they use most. A newer home with full RCD coverage needs a different approach to a character home in Norwood still running a mix of old and updated circuits.
Rather than guessing which points need attention, an on site assessment gives you a clear answer. Book a licensed Sharpe technician for an electrical safety check, and you will know exactly where you stand.
Keeping Little Hands Safe
Australian power points already do more of the work than most parents realise. Shutters alone are not a complete safety plan, though. Cord habits and safety switch coverage matter just as much day to day.
Sharpe Trade Services has been working on Adelaide homes for 45 years, with in-house licensed electricians, a 10-year workmanship warranty, and $20 million in insurance behind every job. If you would like a safety check with kids in mind, book through Easy Book or call the team on 8262 5000.
Frequently Asked Questions
Not usually. Australian shuttered sockets already stop a single object being pushed into a live hole, which is the main job outlet covers do overseas. They can still help as a backup for a curious toddler, but full safety switch coverage matters more for genuine protection.
Check your switchboard for RCD labels next to the circuit breakers, or ask a licensed electrician to confirm coverage during an inspection. Many older Adelaide homes only have partial coverage, which leaves some circuits without protection.
They can reduce clutter by cutting down on separate chargers and adaptors. They still need the same basic care as any power board, though. Keep them off the floor, avoid overloading them, and unplug what is not being used.
Stop using it and get it checked as soon as you can. A warm or damaged point is a sign of a loose connection or wear behind the wall. It is one of the more common findings on a home electrical safety check.
If your switchboard still uses ceramic fuses or only has partial safety switch coverage, an upgrade is one of the most effective things you can do for a young family. It protects every circuit in the house rather than just the ones you remember to think about.